EAW Resolution Manual de usuario descargar pdf (Pagina 12)

Building a Venue

Here are the steps to building a venue within Resolution:

1) Select the type of measurement data you are going to use to build the surfaces (Cartesian,

Polar, Laser). We have selected Cartesian for this example. Using Cartesian measurements

assumes that you have access to room drawings with accurate depth, height and width

dimensions for the venue.

2) The three data points you will need to enter are (X = Range, Z = Height, Y = Width). Enter Start

X to dene where the surface begins on the rst surface. Start Z will dene the height from the

0 reference (lowest possible point). This can either be the oor itself or you may choose to use

the oor surfaces instead as listening levels (ears of the audience). For simplicity, we will enter

0 as the oor.

3) Now you may enter End X. This is the total depth of the rst oor surface.

4) Once this has been dened you can enter the height of the oor at the rear. The angle of the

oor is now dened if the second Z is dierent than the rst Z. If they are the same, a at oor

will be created.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Sin comentarios

EAW Resolution Manual de usuario Pagina 12